Tasks -> Settings -> TV -> TV Signal -> Satellite Transponder Scan -> Single Transponder Scanĥ.1 You must know your cable provider settings and the frequencies / symbols / QAM settings. You'd better start from scratch, if you have already played a little with MCE : Tasks -> Settings -> General -> Windows Media Center Setup -> Run Setup againĥ.
Start MCE and setup the signal as if it was a satellite (just select any of it), no need to scan anything of course.Ĥ.1. Install MCE CI Tool (Version 1.0.0.9 is fine with me) and do not close it ! just minimize.Ĥ. Kind Regards steven Posts: 2227 Joined: Fri 3:23 pmĪctually, it works pretty well with MCE !ģ. Maybe you can have a try with virtual DVB-S driver: Steven steven Posts: 2227 Joined: Fri 3:23 pm Press scan then MCE will get the 474 ,6875 transponder channel list.Īny problem about this.Please reply here, we will answer your question as soon as possible. The value should be 3474MHz(Which looks like the satellite frequency). Set the freq value which is added 3000MHz.įor example, if the wanted frequency is 474MHz, So you need to manual scan these transponder. How To use Virtual DVB-S driver for DVB C cards ?Īfter you installed this Virtual DVB-S driver,Windows Media Center will take TBS6680 as a DVB-S device. In this package has a HowTo.txt you can have a read,here is the detail information: After set the symbol rate then you can open Windows Media Center and enjoy DVBC now.
0 kommentar(er)
